Page 20 of 22
Re: It lives
Posted: Wed Sep 13, 2017 2:31 am
by simpleterm
Yep, I'm using Chrome. And holy Jesus, it worked! For so long I've been annoyed by PhotoBucket and now it works like a charm. Thank you so, so much!
Re: It lives
Posted: Wed Sep 13, 2017 8:58 am
by RGV
It's not photo bucket it's chrome that has made a patch so you view p b pics.
Re: It lives
Posted: Fri Sep 15, 2017 1:22 am
by simpleterm
RGV wrote: ↑Wed Sep 13, 2017 8:58 am
It's not photo bucket it's chrome that has made a patch so you view p b pics.
Yea, I know. I still don't know what PB was thinking when they just wanted $399 from people to see some photos... it's outrageous.
Re: It lives
Posted: Tue Sep 19, 2017 9:19 pm
by RGV
Pistons and new main jets have arrived so I can start putting the motor back together. New carbs are shorter that the old Mikuni's so I need to modify the air box. This was supposed to be a nice easy change over. Yeh right.
Dave
Re: It lives
Posted: Mon Feb 05, 2018 4:25 pm
by RGV
Engine back together and holding pressure.
Re: It lives
Posted: Mon Feb 05, 2018 6:59 pm
by Stayt`ie
ok, I have had stuffall to do with twostrokes in the last cuppla decades,, whats the go with this 7psi
Re: It lives
Posted: Mon Feb 05, 2018 8:21 pm
by harky
Ronnie
2 smokes require a 7lb pre run stabalilisation , saturation period
so the co- efficient between the linea expansion of the rotating bits and the non smoke producing bits
can be pre stressed to help with the eardrum destroying noise outcome
Dave has it sussd to perfection
both in terms of noise and smoke
Re: It lives
Posted: Mon Feb 05, 2018 10:07 pm
by Stayt`ie
ArrrrSooo,
Re: It lives
Posted: Tue Feb 06, 2018 5:19 pm
by RGV
Good to see ya have been paying attention Harky, ya closet smoker.
Ronnie, the amount of pressure isnt that important as long as its in the 5 - 10 ish PSI range. Testing the engine for any leaks. It should hold pressure for round 5 minutes. Air leaks = BAD. If you were to do it properly you would also test with a vacuum but I dont have a vacuum pump or gauge.
Dave
Re: It lives
Posted: Tue Feb 06, 2018 10:05 pm
by Stayt`ie
Interesting, thanks Dave, will catchup with you on the lake and talk more
Re: It lives
Posted: Thu Feb 08, 2018 9:32 am
by AuotonomousRX
It's all about Crank Seals .....
Nice work Dave
Pete
Re: It lives
Posted: Thu Feb 08, 2018 10:24 am
by Stayt`ie
yeah I was thinking that Pete, but also thought that youse may have been working towards a certin crankcase pressure before the transfer ports opened
Re: It lives
Posted: Thu Feb 08, 2018 12:38 pm
by AuotonomousRX
Hi Ron
The old RGV engines are pretty limited as far as what you can do to them ..... about 70 - 75 rwhp (Dyno dependent) is about it .... after all it's a mass produced Road Bike Engine and nothing like a Purpose Built Race Engine that you have in a TZ Yamaha or a RS Honda .....
Some interesting Information has been released since the Smokers were phased out of GP Racing ....
A couple of the Mechanics from the Works Aprilia 2 Stroke Team were able to share what they found based on many many years of R&D ...
and a lot of the last years of the 2 Stroke development they did found the opposite to the older thinking as far as modifications ...
They found, Big Volume and Liquid Cooling in the Crankcase(rather than small crankcase volume), rounded Transfer Port Dividers at the base of the cylinder (rather than thin knife edge), the shape of the Transfer Port Ducts (rather than the size of the port openings), not too much exhaust port timing, longer con rod lengths, all led to a reliable and rideable 54hp out of a 125cc GP Bike in the last years.
A lot of it is not really applicable to the RGV, but it helps to know what areas to change and what areas can be left alone ......
On ward and upward
Pete
Re: It lives
Posted: Sun Feb 18, 2018 9:56 pm
by RGV
Got the bike fired up yesterday. A bit more to do mainly to the cooling system and it will be ready for another try. Ive fitted the old pipes that are a known good thing, after a good run with them on ill fit the new pipes that are worth another 6 hp on paper so we shall see what result that gives.
Dave
Re: It lives
Posted: Fri Mar 09, 2018 7:03 am
by RGV
Bike is packed in the van ready for an after work departure today. We will get a couple of hours down the road tonight and have a sleep then an easy drive in to the lake tomorrow.
Bike is running well on the bench so hoping for a successful speed week. Ill report back after we return in a week and a half.
Dave